Posted on

Another 3D-printed DIY Tiny Whoop frame

3D printed DIY Tiny Whoop frame for both 7mm and 8.5mm brushed motors

3d printed tiny whoop frame
Image from Thingiverse

I just stumbled across this Tiny Whoop frame on Thingiverse and I’m planning to print one. Hopefully it can accommodate a Hubsan board instead of the Blade Inductrix one. You can find the parts I’m planning to use below. The frame can be printed both for 7mm motors and the mighty 8.5mm motors. The AUW seems to be around 37g with 7mm motors, 205mah lipo and a Quanum Elite camera. The frame files can be found on Thingiverse.

Suggested parts list

Motors: 8.5mm motors
Control board: Hubsan H107L X4 control board
Lipo: 300mah 1s, 500mah 1s or 600mah
Propellers: Hubsan propellers
Camera / Transmitter: Quanum Elite or FX797T